fast medium wave halogen heat lamps

fast medium wave halogen heat lamps

We built these medium wave halogen heat lamps for the moments when you need heat—fast. No waiting around. No lag. Just immediate, controllable power that gets right to the point. It’s about turning electricity into intense heat with almost no delay, so your process keeps moving when the clock is ticking.

What’s really happening under the hood

These lamps run on medium wave infrared, which hits a sweet spot between deep penetration and quick response. They’re built to run hot—think 2500W and up—because that’s what it takes to deliver the heat flux your process demands. We match the voltage to real-world industrial power, with 400V options that lower current draw and make wiring runs simpler and cleaner. And the length? Around 300mm. That keeps the footprint small while packing in serious heat density, so you can fit it into tight heating zones without redesigning everything.

The build that takes the heat

The envelope is quartz, because it handles wild temperature swings without blinking and lets infrared energy pass through efficiently. Inside, the halogen cycle keeps the filament clean at high temps, which helps the lamp last longer. A medium wave coating shapes the output to match how many industrial materials absorb heat, so you’re not wasting energy. And the R7s connector? It’s tough, straightforward, and designed for high heat. Installation is a simple two-contact wire-up—clean, quick, and no fuss.

Where these shine—and what to keep in mind

These lamps are right at home in jobs like PET blowing, plastic thermoforming, and adhesive curing. You want heat on demand, and you want control. The fast response means the heating zone hits setpoint quickly, so cycle times shrink. The compact size makes it easy to drop into existing machines with minimal changes. And because of the halogen chemistry, output stays steady over time. Now, the trade-off: with this much heat density, you need proper cooling and thermal shielding. We design the lamp to be a straightforward swap-in, but your machine still needs to be set up to handle the heat. Match the cooling and mounting to the output, and you’re good to go.